Speedster tail garnish

 

 Wanting to soften lines of the rear of the Speedster I though

I would use a bit of a brass as a garnish. 

Using craft paper and masking tape to build a form.

Layed out on a brass sheet.

Sheet cut out.

Creasing a straight line in the tin.

Using the wheel to get a wider radius an 

develop a some-what compounded base.

Cutting the profile wayyy back.

Detail of the lower section.

Inside view of the piece.

The piece clecoled into place

to be riveted.

Also added a right hand turn signal delete panel.

Done!